Wednesday, June 5, 2019

Crappy Raptor Tint Bedliner

[, Music ] at a YouTube and welcome to this episode of the gunman. So this video here is a review and demonstration on the Raptor tentacle bedliner. It'S actually a pretty cool product and if you hang around for the rest of this video we'll have a good look at how it works and the kind of finishes that you can get with it. So I actually made this video quite some time ago, but I've never got around doing the editing, I'm just finally getting around to doing it. Now, there's a few things worth keeping in mind now the prep work can be relatively rough, so you can actually finish your prep work off with even 80 grit, if you like, because the material is so thick, it's going to do a lot of filling work. So this instance here I decided to use a mid to light gray non sanding primer. It'S gon na do a couple of things: it's gon na seal down all the bare metal and it's also gon na act as a bit of a ground color. So, like a bit of a ground coat color, if I was to go straight over the top of that bare metal, it would probably stick. It would probably would actually get adhesion if I was to go straight over it with the tangible wrapper, but it probably wouldn't get covered, because you're only putting 10 % color in with the tangible rough dice. So have a look at me when I'm mixing up this color now wrap the liner. This one here actually came with a gun which I thought was pretty handy and pretty cool good friend you can come to the no fool put them from like an hour sitting on enough to go. This is a 2-pack product, so you're, obviously gon na have to make sure you clean this gummy up. It'S said to put no more than 10 % coloring. So 3. 2 1. It'S a mixture of the Raptor liner with the hardener and I'm guessing 10 %. On top, so I'm going to put a hundred mils of color in I've actually got one here that I already did. I'Ve already put the color in that I'm gon na bring friend. I think that should be enough. People do need to come out and grab another one. I will, though, so what I'm gon na do here is make sure to actually left enough room in there for you to put your hundred mils of color and your 250 mils garden. This is, I don't know if it did. Cuz depends on the can to shake and shoot, but if you fill it with that, and an extra 10 % Keller took the earthen filling soon find out, though yeah I think that's going to overflow, just yeah that'll be good enough with a nice and full, but It'Ll work, so I'd actually also said that you can send it down Feliz 30 percent up to 30 percent value. But if you do decide you wanted to thin it down a bit. Just read the instruction when all else fails read the instructions, a really good shake up to make sure that hardener and colors all the way through there. That'S the one had early for my color in well. I did, though, was simply color unseen. Shirring. Stick make sure it goes dead up there. So that's a laid-off, so 10 % of elite is 100 mils, obviously isn't a personal rocket science hundred mils there, the out 10 %, and then we just fill it just about some thought with this thank and stupid. So these are my first time actually using the tentacle stuff, and I really don't know how well it's going to cover, because there's only like callable is that only at 10 % of it is actual is color. I'M not sure how there's sort of creamy white that it already is actually covers. So you can see the color difference from that to that it isn't 100 %. So this little like milky color to it. But it's pretty fun. You can say what it's like: regionally yeah, that's not getting awesome coverage, I'm really glad. What are we to do the phone, I'm just gon na jump up in there. So as far as the application goes, it really is pretty straightforward. As you see this point and should plug the gun in point and shoot, I didn't actually adjust any air pressures or anything. Now the spray booth from memory was set at about 60 psi. We'Ve got a regulator on the wall of the spray. This on the outside of the spray booth and we've got that step through yeah 60 psi and then whatever that ends up as at the gun is just what I use. So I didn't, actually, you know, use the cheetah felt to choke it down at all, and I would imagine most cases you just be using whatever you've got at your Airlines and that should be fine as far as pressure goes, and there is no other settings on This gun here, so it's just get point and shoot pretty straightforward. So I was going to do a bit of editing down on this video, but I thought you know what, if you don't want to watch the rest of the application for this when you don't have to you, can skip up to the 18 minute and 27 seconds. Mark and I'll go through yeah. Closing thoughts on the product is good. Look at how the job came out and then also a bit of a look at how this entire respray came out. So I think some may have already seen that was a good upload. Some war footage of myself clearing this job here on my roar channel, but those who haven't might want to have a look at how this job came up so yeah. I hope you guys do hang around and watch me spraying this. Otherwise, as I said, keep up to the 18 minutes. Twenty seven second mark andol says there: [ Music, ], [ Music, ], [, Music, ], [, Music, ], [, Music, ], [, Music, ], [, Music, ], [, Music, ], [, Music, ], [, Music, ], [, Music, ], [, Music, ], [, Music, ], [, Music, ] [ Music ] [, Music, ], [, Music, ], [, Music, ], [, Music, ], [, Music, ], [ Applause, ], [, Music, ], [ Applause, ], [, Music, ], [, Music, ], [, Music, ], [, Music, ], [, Music, ], [, Music, ], [, Music, ], [, Music ] [, Music, ], [, Music ] - that was ideal, just ray-bans is all I needed, and I'm really glad I put that brought again because it didn't really come up very well. You might have noticed that the start, but I did that you can say that it was like pretty wet and it still didn't quite cover so yeah. He brought through something like this. I would recommend putting some kind of a primer down ready if it's like a red that really isn't going to cover one petal, maybe actually just to try to read the ombre and then put your art in to wrap the lives yeah. I'M pretty happy that watch there is a few little edges hit like you can see where I stopped here and then ditched it. A little bit and she's gon na touch dry, bitch wan na I've done yeah this. Is it not to be outdone? A couple of other videos on this grab the liner. It'S amazing stuff, guys yeah check that video. I feel I know you enjoyed this one and until next time get out there and fight this jumping out. I'Ve putted one foot of silicon in in this hold up that in, but I'm gon na give this like a good. I want to give it half day off. Sometimes when you hit make on this booth is like stuff plants from Cameroon, so I'm gon na. Let that bus ride off before I hit face not in any hurry on something like this started, a hurry to do it again: either life sandblasting a little bit of a nice flip. There yeah there's a few chips here in there, but, as I said I Spit fists, part of, but based on these towel ready just give it is. It'Ll could have easily spent another another five and it still wouldn't be fair. That'S the thing: it is just race right, a race pray, though I'm quite proud of. Actually I'm really happy with that and hey. Why wouldn't you be? What does they know? Somebody happy to grab that really like I'll put it out of here imperfections in a but at the end of the science, just a race bright. I love it. Beautiful, walk around radio YouTube, so this is a good look at the entire job once it's fully finished. So that's got the bed line and down full respray on this old hate cue, I was pretty happy. I was actually really wrapped with how this came out. It'S not perfect, like you can see a few sort of dry spray marks, but honestly man, it looks really good. It'S something that I would do if I had an old ute with a bit of a banged up old tray, and probably I would even do it if I had a brand new you to protect it, because this stuff is absolutely amazing. As far as protection goes, I do actually highly recommend going and checking out another video that I've done. I put this stuff right through its paces and yeah, probably a bit more of an in-depth review on wrapped on liner itself. I think I'll put a link in this video until next time get out there and plant some thanks for watching. This has been another government production, goodbye, [, Music, ]


Post a Comment